Mon-Fri: 7AM-7PM, Sat: 8AM-5PM Licensed & Insured [email protected] Serving Canton, SD

Driveway Cleaning for Pavers in Canton, SD

Pressure wash with a surface cleaner for pavers. Driveway pressure washing that removes dirt, mildew, tire marks and many oil and rust stains for an even, clean finish. Typical cost $150-$400.

Driveway Cleaning for Pavers is one of the jobs we do most often in Canton, SD. Typical jobs cost $150-$400, and you approve the price before we begin. With pavers, the right approach is pressure wash with a surface cleaner.

How we clean it

Pressure wash with a surface cleanerCleaning method
Usually 1,500-3,000 PSI with a surface cleaner, adjusted to keep joint sand in place where possiblePressure

Cleaning solution: A paver cleaner or pre-treatment; efflorescence needs a dedicated cleaner.

What to know about cleaning pavers

Cleaning concrete and brick pavers removes weeds, moss and stains, but some joint sand washes out with them. Re-sanding the joints, often with polymeric sand, and sealing afterward keeps weeds and ants out and holds the pavers in place.

Avoid: A narrow tip aimed into the joints, which blows out sand and can loosen pavers.

How often: Clean every 1-2 years; reseal every 2-4 years.

Is it time for driveway cleaning for pavers?

  • Dark, blotchy or striped concrete
  • Black mildew along edges and in shaded areas
  • Oil spots and tire marks
  • Rust stains from sprinklers or fertilizer
  • Weeds and moss in cracks and joints

Why it gets dirty

  • Vehicle drips and tire rubber
  • Dirt, pollen and leaves ground in by traffic
  • Mildew in shaded and damp spots
  • Iron in well water or fertilizer leaving rust marks

What you can do yourself

  • Blot fresh oil with cat litter and sweep it up after a day
  • Sweep regularly so leaves don't leave tannin stains
  • Fix leaking vehicles to stop new spots
  • Avoid deicers that contain ammonium nitrate or ammonium sulfate, which damage concrete

Not sure what you're looking at? The free stain identifier and safe pressure guide explain each stain and surface.

Common mistakes to avoid

  • Stripes and swirl marks from using a wand instead of a surface cleaner
  • Etched concrete from a narrow tip held too close
  • Oily wash water running into the street and storm drains
  • Spreading oil around instead of lifting it

How we handle driveway cleaning for pavers

  1. Sweep and inspect the driveway and note stains
  2. Degrease oil spots and pre-treat mildew
  3. Clean the whole surface with a rotary surface cleaner
  4. Detail edges, joints and expansion cracks
  5. Rinse, post-treat and walk the driveway with you

How much does driveway cleaning for pavers cost?

$150-$400Typical range for a typical two-car driveway
1-2 hoursTypical time on site
Once a yearRecommended frequency

What moves the price:

  • Size: square footage of siding, roof or flatwork
  • Condition: heavy growth, old stains and peeling finishes take longer
  • Access: number of stories, roof pitch, slopes and how close we can park
  • Add-ons: sealing, gutter brightening and other services done in the same trip

These are typical U.S. ranges, not a quote. You get an exact price before any work starts. For a quick estimate, try the pressure washing cost calculator.

Other services for pavers

Serving Canton, SD and nearby towns

Freeze-thaw cycles and deicing salt are hard on concrete in South Dakota. Cleaning it in spring and sealing it before winter reduces how much water and salt soak in, which is what causes surface flaking (spalling).

Crews serve all of Canton (ZIP code 57013), plus Harrisburg (10.4 mi), Lennox (15.5 mi), Tea (15.8 mi) and Rock Valley, IA (16.4 mi). Call (555) 010-0000 for a free quote in Canton.

Driveway Cleaning for Pavers: frequently asked questions

How much does driveway cleaning for pavers cost in Canton, SD?

Driveway Cleaning for Pavers typically costs $150-$400 for a typical two-car driveway, and usually takes 1-2 hours. The exact price depends on the size and condition, and you get it before any work starts. Call (555) 010-0000 for a free quote.

Do you use high pressure for driveway cleaning for pavers?

For pavers: usually 1,500-3,000 PSI with a surface cleaner, adjusted to keep joint sand in place where possible. What we avoid: a narrow tip aimed into the joints, which blows out sand and can loosen pavers. We keep the pressure even and controlled, with the right tools for the surface.

Is driveway cleaning for pavers safe for my plants and pets?

We pre-wet plants and lawns, keep cleaning solutions diluted to what the surface needs, and rinse landscaping again when we finish. Keep pets and children inside until surfaces are rinsed and dry.

How often should I schedule driveway cleaning for pavers?

Clean every 1-2 years; reseal every 2-4 years. Shade, nearby trees, humidity and heavy traffic mean more frequent cleaning; sunny, dry spots can go longer. Our free cleaning frequency tool gives a recommendation for your climate.

What if it rains on the day?

Light rain doesn't stop most washing, but heavy rain, high wind, lightning and freezing temperatures do. If the weather isn't right, we reschedule at no charge. Our work is backed by a satisfaction guarantee.

More services

Popular Exterior Cleaning Services in Canton, SD

Graffiti Removal for Brick

Low-pressure wash. Brick is tough, but the mortar joints are softer than the brick itself, and older soft-fired brick can pit.

Typical $200-$800

Pressure Washing for Pavers

Pressure wash with a surface cleaner. Cleaning concrete and brick pavers removes weeds, moss and stains, but some joint sand washes out with them.

Typical $150-$600

Pressure Washing for Composite Decking

Low-pressure wash. Composite decking doesn't need staining, but it does grow mold and mildew, especially in shade and between boards.

Typical $150-$600

Parking Lot & Garage Cleaning

Cleaning parking garages, lots and loading areas to remove oil, grime, gum and litter.

Typical $500-$3,000

Pre-Paint Washing for Fiber Cement Siding

Soft wash. Fiber cement siding is durable and holds paint well, but its factory finish can be marked by high pressure, and manufacturers' care guides generally recommend low-pressure cleaning.

Typical $250-$600

HOA & Apartment Pressure Washing for Brick

Low-pressure wash. Brick is tough, but the mortar joints are softer than the brick itself, and older soft-fired brick can pit.

Typical $800-$5,000

Efflorescence Removal for Concrete

Pressure wash with a surface cleaner. Plain broom-finish concrete is the surface pressure washing is made for.

Typical $200-$600

Efflorescence Removal for Pavers

Pressure wash with a surface cleaner. Cleaning concrete and brick pavers removes weeds, moss and stains, but some joint sand washes out with them.

Typical $200-$600

Exterior Mold & Mildew Removal for Fiber Cement Siding

Soft wash. Fiber cement siding is durable and holds paint well, but its factory finish can be marked by high pressure, and manufacturers' care guides generally recommend low-pressure cleaning.

Typical $250-$700

Soft Washing for Asphalt Shingle Roofs

Soft wash (no pressure). The black streaks on many asphalt roofs are a type of algae, often Gloeocapsa magma, that feeds on the limestone filler in shingles.

Typical $300-$800

Restaurant & Drive-Thru Cleaning

Cleaning drive-thru lanes, restaurant entrances, patios and grease areas, usually overnight.

Typical $200-$800

Soft Washing for Cedar Shake Roofs

Soft wash. Cedar shakes grow moss and lichen and turn gray as the wood weathers.

Typical $300-$800

Ready for a cleaner home or business?

Get a free pressure washing quote in Canton, SD. Tell us what needs cleaning and we'll give you a price and the next available date.

Call NowFree Quote